Try getting a new USB stick with a few songs on it. Put it in and start your car. Shut it down and try putting the original USB drive in. Apparently, the stereo sometimes does not read any new songs that were added to the USB drive, so you may need to have it re-import all the songs. TheWeezel • 9 yr. ago. With this new device, both monitors work and the firmware is updated via the 1.02 tool, so all good there. The problem is, if I unplug the thunderbolt cable and then plug it back in again, the USB ports stop working. I do not know if this issue was present with the old TB16 as I was preoccupied with the dual monitor issue. The front washers are fine and I can hear the pump working when I try to wash the rear window. The bottle is full, I always use a screenwash and I have cleaned the nozzle over the rear window. One thing I have noticed is that, if I operate the rear window washer for between 5-10 seconds, water start to run out from somewhere in the engine bay 500. The FIAT 500's USB port may stop working properly. To to troubleshoot, check to see if a connected device or phone are still charging and whether power is reaching either of them. A faulty port will fail to power anything connected to it. A more common cause of USB malfunction, is due to faulty software. Perform a reset of the FIAT's Audio That's a USB 1.0 in there that can't handle much power. My set up is like this: 1. Aftermarket Bluetooth streaming module in the glove box. Plugged into the USB for power and into the AUX port for sound. 2. Cigarette lighter power charger for the phone. 3. Magnetic mount in the CD slot for the phone. This is why the 500 does not do well in the J.D. Powers Initial Quality Survey: "Can not find USB port to connect MP3 player as auxiliary sound device". The 500 is a very cheap car. Not all of its customers graduated Magna Cum Laude. Tedolph. K. kate Discussion starter. 3 posts · Joined 2015. #5 · Jun 17, 2015. Wp0DFPR. Messages. 2,524. Points. 451. Location. Oxfordshire. Dec 27, 2020. #10. Wireless Android Auto & Apple CarPlay will be available on the new electric 500, which has a new UConnect system (on some spec levels) but otherwise it only works with a wired connection on Fiat cars. Usb is not working to play music 2013 Abarth. I just recently acquired a 2013 fiat 500 Abarth and went to plug my iphone XR into the media centre and it will not play the music. The Iphone stops playing the music outloud like it is connected but then the fiat says no source available. If you are using the USB device via a USB docking (USB hub), try connecting the USB device to the computer directly. If the USB device is able to work normally, then the USB docking may be faulty or the power source of the docking (hub) is not enough. If the problem persists, please continue the next troubleshooting step. Back to Table of Contents Nov 27, 2017. #1. I just purchased a used 2014 500 pop this last week. I already love it. A few days after I purchased it I tried to charge my cell phone and discovered that the power socket/cigarette lighter doesn't work. Easy fix I thought, replace the fuse (f15). However, it didn't appear to be bad. I replaced it with a known good fuse anyway. To reset your TomTom device, do the following: Check that the battery is charged properly. Charge your device for at least 2 hours before trying to turn it on again. Make sure the charging light on your device is on. Remove the SD card. If your device uses an SD card , remove it. Reset your device. Use a straightened paper clip, or something

fiat tipo usb not working