If you’d like to know where the VIN is in the Fiat 500, the VIN on a fixed part of the 2007-2015 models is located on the boot floor. The popular Fiat Croma, produced in 2008-2010, had the VIN number on the fixed component on the floor next to the passenger seat (at the very threshold) and the VIN plate on the left-hand side reinforcement. VIN Decoder Fiat VIN was first used in 1954. From 1954 to 1981, there was no accepted standard for these numbers, so different manufacturers used dif View All Posts Circle Track Warehouse has a lot of used NASCAR parts that you may want to check out as well. On the 7-bar, the crossmember at about shoulder height for the driver, there should be a chassis number and build date, typically in about the location you'd imagine that a passenger seat would be. The M6 tapped hole on the top of the alternator is there to mount the suppressor by means of a "P" clip and connects to the large terminal on the alternator. The correct mounting for the earth wire/strap is from the Dynamo or alternator mount back to one of the rear panel mounting studs both on the 500 & 126. Feb 13, 2009. Messages. 249. Points. 82. Feb 22, 2009. #8. the reason i kept starting new thread was because it was on a different topic, ie engine code, chassis number etc so i thought it would be helpful to other who do the search. sorry if i annoyed anyone it was really not my intention as you have all been so helpful, i am really a novice 379. Points. 87. Apr 16, 2021. #2. It should be stamped into the floor between the edge of the right-hand seat (passenger seat if LHD) and the door opening, running alongside the seat frame from a point near where the handbrake cable goes through the floor. There would originally have been a flap in the carpet, but as most have been replaced vBwj. After chasing down individual posts via search and creative search terms, I would love a single thread with pictures and info on wheels that fit our cars. Seen it on most of the other forums I have frequented, curious why there is not one here Went to change the cheap, sheet metal vertical chassis braces (on both sides behind each front wheel) with the Madness aluminum braces (very well made). To my surprise, on my 5,000 mile Abarth, the four bolts (two each side) in the stock pieces, were barely finger tight. I can't believe they left the factory this way so they must have loosened Mar 18, 2009. #5. devilz_own said: Blue dot on Punto badge means it should be an active (base model) chassis number should break down into something like. ZF = country of origin and manufacturer ID. A199000 = spec of car (ie trim, no. of doors, engine type and other tech info) last 7 numbers indicate age of car so the higher the number the 08-24-2016, 02:23 PM. Originally posted by Fiat500USA. Factory camber spec on a 500 Abarth is - 1.50°, with a range of -1.00° to -2.50°. A hint is when you do struts on the car, pushing against the top of the tire/wheel assembly while tightening the anchoring bolts will help you get into the required range. View and Download Fiat 500 owner's manual online. 2013. 500 automobile pdf manual download. Also for: 500c, 2013 500, 2013 500c.

fiat 500 chassis number location